This 4 channel chaser runs 13-19 feet of EL Wire per channel and comes with plugs so you don't have to solder.

Animate a short sequence with this 4 channel chaser. Uses 4 AAA batteries (not included) so you can make it mobile. Use with our pre-connected El Wire for simplicity or attach a lead to each section of your EL Wire and you can swap their locations on the chaser as you please. Each channel needs to have a load (EL Wire) on it for the sequencer to run. Do not operate without EL Wire on each connector. This can damage the unit! Runs off 110 volt or 4 AAA batteries. Comes with 4 EL Wire leads and on/off switch.

Design note: You can combine leads on a single piece of EL Wire to increase your blink rate or create odd blink patterns. This chaser has a short lag time between chase sequences so you will not get a smooth transition. This is a chaser only. There are no alternate patterns. It fires one piece of wire followed by the next and so on, and then repeats. DO NOT attach more inverters to the EL Wire output leads.

Dimensions: 3.5" x 2.25" x .875"